So, I have a pretty accurate load based on the Lyman 225438 powder coated and checked. I use one of Al's expanders to get a good clean seating, works very well. The issue I am facing is one that I am not used to dealing with... How to crimp the darn thing. I have the Lee die set and and am not happy with the crimp. I would like to find a decent taper crimp die. All I want to do is fit the neck down to the bullet, I really do not want a strong crimp. The bullet is held well enough by neck tension, but the last step on the die leaves them just a tiny bit open.
So, what are all of you doing in this case?