My home built HighWall single shot 38-55 project is nearing completion (baring no farm equipment breakdowns!) and I am going to be buying dies and molds now. Since this is my very first experience with the 38-55 I can only guess as to where to start if I do it on my own so here are the particulars, barrel blank is a Green Mountain 1-12 twist .375 x 27" long (actual finished and installed length should be 24" to 25"), would like to go longer length but 27" was as long as was available at GM in the raw blank version. This is going to be mainly a paper and steel plate killer with maybe the possibility of occasional long range Coyote sniping (my trusty T/C Contender carbine in .204 Ruger usually serves that purpose), these paper/steel targets are at 100, 200, 375 yards but a bullet that would work at longer ranges would be desirable. I have a bunch of different caliber Lee molds that were cheap and ok (barely) and would consider another one if there happens to be an exceptional one for this caliber, which I seriously doubt is the case, but I think I would rather buy a quality mold with a bullet of known quality and performance for what I intend to use it for an suggestions?