CLOSED: New 25 caliber small bore design 257-640

[2 dogs]

Updated.

To me, it stands to reason if Miha is going to do a 3 cavity .257 caliber on a 2 cavity brass mold then a 6 cavity .257 caliber should work on a 4 cavity brass block.

Somebody correct me if'n my beans are cold....

[Teemu]

I'm in for 3-cavity PB/HP brass. Thanks. paska_10 At hotmail Dot com

My reply #4. I could also take .260 diameter if offered. If not still want this mold. Thanks

[Dpmsman]

I’m in jstahlconstruction at yahoo dot com

[2 dogs]

I’m in jstahlconstruction at yahoo dot com

I got it buddy but you gotta tell me WHAT exactly you want me to put you down for please.

[2 dogs]

My reply #4. I could also take .260 diameter if offered. If not still want this mold. Thanks

Ok, you guys can be a challenge but I took my best shot at it!

[square butte]

Ain't Life Grand

[SethD]

After some thought I would also like a 4 cavity solid plain base. Seth Doty 444 at Gmail dot com.

[Dpmsman]

I got it buddy but you gotta tell me WHAT exactly you want me to put you down for please.

Sorry about that! One 3 cavity GC HP mould please. Thanks much!

[2 dogs]

Please don't make me go hunt your email address when you are updating or changing your mold preference. I need your email address like this:

bigcaster AT moldworld DOT com and don't get all excited and forget what mold you want!

[2 dogs]

NOTICE: This buy closed on the SA.COM side so now would be a good time to get off the fence if you are wanting this mold.

[2 dogs]

This group buy is CLOSED

[alamogunr]

I just found this thread and would like to get in. It looks like my only option for my .25-06 is:

3 cavity cramer HP's on two cavity brass blocks

Any chance you can add me for one mold at .260 dia.?

alamogunrATcharterDOTnet