Titan ReloadingMidSouth Shooters SupplyLee PrecisionWideners
RepackboxInline FabricationRotoMetals2

Page 2 of 2 FirstFirst 12
Results 21 to 22 of 22

Thread: Cleaning primed cases

  1. #21
    Boolit Master RED BEAR's Avatar
    Join Date
    Oct 2011
    Location
    1 mile from chickahominy river ( swamp)
    Posts
    1,622
    I have polished primed brass for ever. Never had a problem. I always resize ,
    bell , polish and prime cases and put in airtight container when ready to reload give them a polish and load. I have been doing this way since late 70's and never had a problem.

  2. #22
    Boolit Master
    Join Date
    Sep 2016
    Posts
    610
    You want to get the lube off the exterior of the case? I've cleaned off loaded rounds by dumping them in a towel, spraying the pile with rubbing alcohol, making the towel into a hammock sling and running the rounds back and forth from one end to the other. The alcohol dries fast, but takes off the lube pretty well.

    You could spray the towel first and then dump on and clean the pulled, primed cases. With the towel holding the solvent, I don't think any will get all the way into the cases' primers. Also, setting the cases in the hot sun afterwards (you're still in HI, right?) should evaporate off any little bit that did get in. There really shouldn't be any primer contamination this way.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check