I have a couple stocks and forends that need to have cuts on them and I want the cuts square with the stock and do not want any angles. I have a chop saw with a 60 tooth blade and a an old saw table combination where you put a piece of wood in clamp it down and the saw rides inbetween two upright poles with guides on the front and back so basically the saw blade runs true.As usual any help or comments. One forend is for a BSA single shot 22rf target rifle.The end towards the action the cut is neither true 90 angle and the cut is angled off to one side. If you are familiar with these rifles the gaps are apparent. Frank