Hello Guys
We are going to run this one in Hollow Point 2 or 4 Cavity Brass and in 8 Cavity Aluminum Lee style or 6 Cavity Brass.
This is a very very good shooting bullet and has been very accurate for many shooters.
I have personally shot it in 9mm, 38 special, 357 mag and have been very very happy with it kind of my one does all bullet for general plinking and accuracy shooting. It fly's like a lazer beam, and it is very forgiving I have found many loads with different powders it likes - Clays, HP38, Unique, HS6, Red Dot.
Here is a pic of the design -
Here are the specifics -
One of the best flat nose design 9mm 155/147gr competition bullet out there. This would be identical to the MP 359-135 (same ogive).
The as cast weight is 155 grain in Solid form it is designed with a small bevel base.
Can be cut for 147 SOLID in Flat base configurations
Can be cut for 155 SOLID in bevel base
Available diameter is .357
Weight can vary +/- 1-2 grains depending in alloy used. Available diameter is .357
Cost for molds is as follows -
2 Cavity Brass HP: 95 euros , all pins, top punch and allen keys
4 Cavity Brass HP: 135 euros , all pins, top punch and allen keys
6 Cavity Solid Brass 95 euros , top punch and allen keys
8 cavity aluminum Lee Style solid 95 euros , top punch and allen keys
These prices will be converted to us dollars when you get the PayPal invoice.
GROUP BUY DISCOUNT OF 15% PERCENT GIVEN AT TIME OF INVOICE
This is a standard buy 10 to go active and when we get around 100 pins it will close.!
Trying to help Miha stream line mold making I want to set a one size for this buy lets say .359 as guys can add diameter with coating and it will still size well. Lets hear you thoughts??
Diameter will be cut at .359 on these molds as sizing down is easier that making them larger and the original design was spec'd to cast at .359