This was the most applicable sub forum that I figured my problem could be posted. Anyway.... I was trying to deprime and resize some PSD brass and had trouble getting the primers out. I am using a Hornady die set with the zip spindle. I could get the primer about 3/4 out and then the decap would let loose and that was it. Shell stuck in the shell holder because the primer was not all the way out and decapping pin "zipped out". I tried to tighten the decapping pin pretty tight. The pin was set @ 3/16" below the end of the die like the directions explained. I realize PSD is a military crimped primer. Has anyone else had trouble with this brass? Maybe a different die set?