As some might remember a short while ago I tried a Hornady bullet feed die on the press and that just didn't work out one bit. So I was finally able to pick up a RCBS Tube Fed Bullet feed die and got it put on the press and adjusted. Well last night I finally had time to run a test sample with this and am quite pleased to say the least!
This die works very well and only missed 2 drops but I believe that was because a bullet hung up in the tube and I didn't notice it. That hang up reduced the bullet stack weight and once I figured that out I didn't have a problem again until I was down to the last 4 or 5 in the stack.
This has achieved just what I was hoping which wasn't a gain in production rate but just an ease in placing the bullets on the ready case which is located all the way to the rear of this press. I really do believe this is going to work and make things much more enjoyable.