7.92x33 KRUZ LOADS

[augercreek]

I'm going to start loading for the 7.92x33 KURZ and want to be in the cat sneeze area. Any recommendations?

[Uncle Grinch]

Interesting... I’ve read about this cartridge, but have never seen a firearm for it nor have seen any brass. Graf’s does have it in stock. Curious, what are you shooting it in?

[Larry Gibson]

Also curious about what rifle?

For cat's sneeze loads I'd look at the NOE 325-133-FN PB loaded over Bullseye (3 - 5 gr....loaded to 800 - 1050 fps). Or for a potential bit more the NOE 328-135-FN GC loaded over Unique up through 1800 fps.

[stubshaft]

I had a SAKO in that caliber and it was a great rifle. Unfortunately I only shot J-words thru it.

[augercreek]

I have stubbed a 94 Stevens shot gun barrel with this calibre. Reamed and chambered in a 7.92 Mauser barrel and fitted it to the shot gun barrel. Put a red dot reflex sight on it. I've also been thinking on a Mauser type action made into a single shot with this calibre. I love single shots and have a few to play with. RBs,Rugers,37 win. 94 stevens.

[Texas by God]

I would think that you could use 7.62 x39mm starting data. For cats sneeze follow Larry's advice.
Tell us more about those rifles! I'm thinking of doing a stub with a section of MN Barrel in a 20-gauge. I will probably chamber it for 32 H&R Magnum. I made one in a 12 gauge Topper stubbed to 44WCF last year and it has been a delight.
Sent from my SAMSUNG-SM-G930A using Tapatalk

[Texas by God]

I had a SAKO in that caliber and it was a great rifle. Unfortunately I only shot J-words thru it.

I always wanted a 7 x 33 mm Sako but I have never seen one.

Sent from my SAMSUNG-SM-G930A using Tapatalk

[augercreek]

I have four 94 Stevens barrels that I've stubbed and one Win 37.only one butt stock for each. For the 94s 7.62x39, 7.92x33, 7x30 waters. With factory loads for the 7x30 I found that the firing pin hole needs to be bushed. The Win. 37 is 32 H&R mag. I would like to make a barrel in 38 s&w for it.