My box of small rifle primers (gynex) is almost empty: 10.000 pcs.
Only meant for the ar 15, i must admit it was hard work to reach this number.
With military iron site at 110 yards/100 meters: 2 inch groups are always there, except when i/we are in a playful mood.
I don't even weigh them anymore, just size/lube and gs em.
If i would really go the full mile, yes 1 inch can be done, for sure!
I don't own a top notch, top shelf ar rifle, just a affordable average joe, 13 in a dozen ar15 from dpms, twist?
I am no match shooter, just 35 years experience, but they perform after some experimentation the same and a bit better than the jacket ones.
Side note: My pet gun the parkerhale1200 308 with lead boolits up to 300 yards/330 meters, 3-5 inch.
No scope on it. No jackets allowed anymore! Just 22-25 bhn.
Both rifles were shot in prone position, no belt.
I use 16-18 bhn and 15,8 grains d060, there is no need to use pure lino.
Pure lino is ~35-40 bhn, for "full jacket" loads you can do easy with 22-25 bhn.
High velocity "full jacket" loads, yeah i use pure.
Sorry to say but still no fouling or a clogged up gaspipe.
Rcbs mold 55 gr.
@JBinMN, Soon i am in a casting session again, for all i care you pm me your address and i will send you some.
Tomorrow, i can figure out roughly how much it will cost me to send it to the usa.
Size .225, lube beeswax and lithium grease and aluminium homemade gc.
If you like of course.
Due to our laws i can NOT send you compleet ammunition, only the lead casts.
But you must do this anyway yourself: you only have to figure out two things:
Setting depth, and your start load.
With best regards.