I bought it new a the summer before last and have only had it out three times running cast through it so far. I did push the envelope on it a few times with loads. I noticed yesterday when cleaning it when the bolt is out the trigger assembly rattles side to Side. It sounds like a baby rattle. When I put the bolt back in it tightens up a lot better but still has play. After I cycle the bolt to cock the rifle it’s pretty close to solid but not completely tight. Is this normal on Ruger Americans? Ruger did send me a call tag to send it in but I didn’t want to send it in if I don’t have to. It seems that either the pin holes are hogged out in the trigger group or it seems like the trigger itself is too narrow VS the the receiver it plugs into.