So I have recently begun powder coating with good results. However, I did have interesting experience when sizing. I have used Lee push through sizers (No lube for sizing) for most calibers I powder coat and had great results. I don't have a push through die for 44 so I used my lube-sizer with a .432 die. Thinking I was smart I spritzed the bullets with some spray on case lube (Frankford Arsenal) to ease the sizing operation and despite the lube I was having a lot of difficulty and even had to knock out a couple of stuck bullets. So, I cleaned things up and started pushing them through dry and surprisingly (To me anyway) it was an effortless operation after that. Has anyone experienced this, where lube actually made it harder to push a bullet through a sizing die?
Anyway, if your lubing bullets before sizing and having a hard time you might give it a shot lube free and see how it works.
Mike