I've had this furnace over 40 years and recently the thermostat & interior wiring were burnt completely up. I obtained stove wiring and after connecting it straight to the heating element, plugged the pot in to see if heating element had been damaged. It worked and got the lead to a temperature of 900 degrees. I began looking on net for a thermostat and discovered one(B-200)that might work at a company called Bilbee. While looking on their site, discovered an item called Robotemp Units. There are two units listed and one is a solid state unit.
I know nothing about electronics and but have a question. Since my pot is straight wired at the moment, could it be plugged into a Rototemp Unit and used to control the temperature of the pot?
I would like a temperature range of 650 to 770.
Thanks