I have (and use) THREE of these -- all equipped with the Ohaus powder measures of same generation. I have each set up for a particular "fuddy duddy" caliber, with empty powder measure in each having a 3" x 5" card with powder used, amount set for, as well as bullet it's complementing in it. When I need/want to load some, say, .38WCF (aka 38-40) it is soooo much easier just to move the AA press to bench, dump in some powder, and after scale-measuring to ascertain all is "OK" -- load away! My 1st of the three was my 2nd ever press, following a RCBS Rock Chucker single stage. That it is still so great -- after about fifty years, is why -- through years past -- I acquired the other two -- and, as stated, still use them. The only note I add is -- should you get one -- to keep the wee screw opposite the die you're using's slot TIGHT against bottom of the turret. This little screw's contact is, imho, MOST germane to insure the settings of your dies. A great press.... good luck!
geo