Pricing for multiples Updated to add a SDB disconnect and Powder alarm disconnect. See below after the original
I've been working on a Quick Disconnect for the Dillon Powder feeder.
Finally got it working to my satisfaction and wanted to offer it to you guys that use the Dillon machines.
This fits on the RL550, 650XL and the 1050 presses replacing part number 13939 and the two screws.
Comes with the disconnect, pair of screws, nuts and springs. It is plenty heavy duty and won't break.
Simple enough to use, just pull it out and lift off the Powder feeder. No screws to loosen and drop, no allen wrench needed.
Seconds rather than minutes, and no reason not to dump your powder back where it belongs when you are done reloading.
I'm including a little case feed stop also, it is only for the 650xl as far as I can tell.
A few pictures below. See the Brown piece in the pictures for the disconnect.
These are available in Black or Silver right now. $15 Including shipping, For multiples, $15 for first, and $9 for each additional. Check, MO or Paypal. Yes concealed CASH is fine, your risk!
PM me if interested in purchasing. And let me know Color you want!
OK, I've been working with Walter Laich and he's tried several to confirm it will work properly on the Dillon SDB feeder.
It replaces the #13986 clip with screw, but in this case only a single screw. This ALSO fits the Dillon Powder Alarm for the 650XL (and any other presses that you might have one one)
I'm using it on mine and it works fine. Makes really easy to swap from one to the other die set.
Right now I'm offering these in black, (silver when I get material back in stock) By itself, one will be $13 shipped, If you want multiples will be $13 for first, and $7 for each additional, a bunch fit in same bag.
And if you want one of each for your 650xl,(powder and powder check) it'll be $22 shipped.
Pictures below: First the SBD/Powder Alarm
SDB / Alarm disconnect
installed Turned to remove, this single screw makes this possible
550/6501050 Disconnect
Silver and Black available
Case feed stop
Thank you guys for looking!
John