Graf & SonsMidSouth Shooters SupplyStainLess Steel MediaInline Fabrication
RepackboxRotoMetals2Lee PrecisionTitan Reloading
Wideners
Results 1 to 4 of 4

Thread: F&S head stamp brass

  1. #1
    Boolit Bub
    Join Date
    Dec 2013
    Location
    Ga
    Posts
    32

    F&S head stamp brass

    I was depriming some 223 cases that I purchased from kingstrider. I broke a couple of depriming pins and had the pin push up on a Lee die. I found that the brass with the F&S head stamp has a very small flash hole. I had never saw it before and finally found out on the internet that it is Field and Stream brass. If you find any you may want to scrap it.
    Mike

  2. #2
    Boolit Master
    NoZombies's Avatar
    Join Date
    May 2009
    Location
    N. Florida
    Posts
    2,153
    I think that's brass from the ammo Dick's is being sued over at the moment...
    Nozombies.com Practical Zombie Survival

    I collect all things .32. If you have something you don't need, please let me know!

  3. #3
    Boolit Master

    nicholst55's Avatar
    Join Date
    Jan 2007
    Location
    Daegu, Korea
    Posts
    2,843
    Not familiar with that headstamp. The Cartridge Collector's database doesn't list it, either. There are several companies that make brass with smaller than normal flash holes - Lapua being one (for some calibers). Some die manufacturers offer a smaller diameter decapping pin for this situation. Sinclair offers a reamer to enlarge the hole to 'normal' diameter. You could do the same thing with a numbered drill bit set - just don't get carried away.

    If I only had a few pieces of this brass, I'd probably just pitch it into the recycle bucket. Otherwise, I would seek a permanent solution, as I described above.
    Boycott YouTube

  4. #4
    Boolit Master
    Join Date
    Apr 2006
    Location
    East TN
    Posts
    752
    I found that CCI Blazer brass in .357 Sig has a really small flash hole. That small hole will allow a conventional small diameter RCBS primer decapping pin to pass through the hole and remove the primer, but then it grabs and holds the pin so tightly that the pin separates from the pin holder. My solution to this was to use a Lee decapping pin for removing the primer, also to remove the decapping assembly from the sizing die. The Lee decapping pin held up with no problems during this procedure. These changes worked well and ended the frustration. I had more than a few pieces of this brass to process on their way to becoming 8mm Nambu cases.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check