Help, messed up my mold.

[Tony2020]

So I had been very happy with my lee 230 grain 309 mold. After a few uses I decided to give it a quick scrub with a toothbrush. Well I dont know what I was thinking, the mold was still way too hot and the bristles melted all over the mold, I cant get the gunk off, any ideas or is the mold shot?

Thanks
Tony

[redhawk0]

Get it reeeeal hot and use a brass brush on it....gently.

You can also try soaking it in acetone...but no promises with this method.

redhawk

[Walks]

Propane torch and bronze brush ?

[tja6435]

Rub the plastic out with a popsicle stick

[Bazoo]

I did the same thing once. Well, I got it out by soaking it in hoppes a few days, and taking a wooden scraper and picking at it. I also used a bronze brush gently, in a side to side motion in the cavity. It worked. Lacquer thinner did nothing, as it will not melt the plastic that the bristles are made out of.

[rancher1913]

its a lee mold -------- just buy another

[LUCKYDAWG13]

Try and boil it off ? or maybe freeze it it might just flake off

[Rcmaveric]

Acetone should dissolve the plastic. Using a popsicle stick and torch sounds good.

Sent from my SM-G950U using Tapatalk

[flyingmonkey35]

Photos or it didn't happen.

Blow torch just melt it off

Sent from my N9560 using Tapatalk

[ShooterAZ]

Yep, blowtorch & burn it out. I'd even try "casting" it out first. Personally, I wouldn't scrape on it.

[Tony2020]

Thanks for the help everyone. A brass brush is already working... slowly. I am going to soak it in solvent again tonight and keep working at it until its clean.

[Mxrick55555]

I did something similar once... I read somewhere that wax was a good mold lube for the spure plate pivot and lock points so while it was hot I touched a piece of crayon to those areas and immediately regretted it the wax ran into the mold cavities and was a mess think I ended up just casting a bunch until it finally melted/ came out of the cavities. Never again!

[Dragonheart]

Give it a soak in "Goof Off"