RotoMetals2MidSouth Shooters SupplyLee PrecisionInline Fabrication
WidenersTitan ReloadingRepackboxGraf & Sons

Results 1 to 4 of 4

Thread: update on my lee 309 160 mold (thanks everyone)

  1. #1
    Boolit Master corey012778's Avatar
    Join Date
    Jan 2008

    update on my lee 309 160 mold (thanks everyone)

    ended up lee menting the mold. problem child was the font cavity but did both. done, doing these is unnerving to me. fudge up a mold last time I tried. could not get the screws to bite into the lead even with a pilot hole. so I took the phillps head bite for a drill just like the screw up with the center and started working the polish.

    did not cavity with mother mag and aluminum polish did the other with rubbing compound, both did great. cleaned up the mold. heated the mold up on a burn for a while. wiped out with. started casting

    did not smoke either mold or use dry lube at the start of the casting session. front cavity stuck. smoked it. drop out right when I open the cavity. about 10 boolits in the rear cavity started to stick smoked it. no problems until 20. rear stuck again. one more round of two. looked at the top of the mold. wiped it off with a cloth as well as the bottom of the spur plate. next set, the front cavity boolet went fling across my casting area, I just opened the mold a little

    around 70 boolits later. I called it. was only wanting to do maybe 20 lol

    long story short thanks for all the advise. did give a good try but had to do the lee ment. going to add wiping the top of the mold and the bottom of the spur plate every 10 to 20 sets.

  2. #2
    Thanks for letting us know what worked in the end. So many requests for help and advice without resolution.
    This way the next person looking to solve this issue knows better what to try first.

  3. #3
    Boolit Master

    gwpercle's Avatar
    Join Date
    Sep 2011
    Baton Rouge, Louisiana
    I just love a story with a happy ending ! ATTABOY

    I used to smoke my moulds also but when I found how well dry lube coating worked I stopped
    smoking , leaves moulds much cleaner and helps prevents rust.
    No more pesky soot to clean off .
    Last edited by gwpercle; 09-29-2018 at 10:50 AM.
    Certified Cajun
    Proud Member of The Basket of Deplorables

  4. #4
    Boolit Master corey012778's Avatar
    Join Date
    Jan 2008
    I was try to see if it would drop without anything, smoking was the safest at casting temps. Do have have another issue. If is what I think it is. Should not be hard to fix

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check