RepackboxMidSouth Shooters SupplyTitan ReloadingSnyders Jerky
RotoMetals2Inline FabricationReloading EverythingLee Precision
Load Data Wideners
Results 1 to 4 of 4

Thread: 310 tool advice, please

  1. 09-28-2018, 01:33 PM #1
    LRRifleman
    LRRifleman is offline
    Boolit Bub
    Join Date
    Sep 2017
    Posts
    44

    310 tool advice, please

    On the old 310 dies, do the seating die stems for cast bullets correspond with the top punch number linked to the different cast bullet molds?

    I noticed that the seating stem for 38 round nose bullets is 311 (the same as the lubrisizer top punch). Does anyone know which seating stem I would use for wadcutters or semiwadcutters?

    Thanks in advance!
    Reply With Quote Reply With Quote
  2. 09-28-2018, 04:12 PM #2
    sigep1764
    sigep1764 is offline
    Boolit Master
    Join Date
    Mar 2014
    Location
    St. Louis
    Posts
    2,043
    http://ps-2.kev009.com/ohlandl/310/Lyman_310_Tool.html

    This site says yes!
    Reply With Quote Reply With Quote
  3. 09-28-2018, 06:15 PM #3
    BrassMagnet
    BrassMagnet is offline
    Boolit Master



    BrassMagnet's Avatar
    Join Date
    Apr 2012
    Location
    SE Missouri
    Posts
    2,926
    Somewhat. Not always. I can decode them for you.
    Reply With Quote Reply With Quote
  4. 09-28-2018, 10:56 PM #4
    Char-Gar
    Char-Gar is offline
    Boolit Grand Master Char-Gar's Avatar
    Join Date
    Mar 2005
    Location
    Deep South Texas
    Posts
    12,820
    This is not an answer to your question about 310 tools, but I turn the seating screws dead flat for use on SWC and WC bullets. They work with any bullet with a flat on the nose. I do this with 310 dies as well are the larger ones.
    Attached Thumbnails Attached Thumbnails 004.jpg  
    Disclaimer: The above is not holy writ. It is just my opinion based on my experience and knowledge. Your mileage may vary.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check