WidenersRotoMetals2Lee PrecisionMidSouth Shooters Supply
Graf & SonsStainLess Steel MediaTitan ReloadingInline Fabrication

Results 1 to 6 of 6

Thread: Range Scrap and muriatic acid test

  1. #1

    Range Scrap and muriatic acid test

    Good morning everyone!

    When I was melting down range lead over the weekend and casting ingots, I put aside a few ingots that had a different coloring in a few spots. I picked up some muriatic acid today and put a drop on those discolored spots and got an instant, vigorous fizzle. Are there other "contaminants" that could be found in range scrap lead, other than zinc, that could cause a reaction like that? I am wondering if I should toss those 6 ingots or if here could just be something else in them that I can simply flux out on the next melt (something other than zinc).

    Thanks in advance for the casting-chemistry lesson!

    Mike

  2. #2
    Boolit Master

    Join Date
    Oct 2009
    Location
    England,Ar
    Posts
    3,985
    I don't know of other metals that will react like that but there may be some. There are zinc and other lead free bullets out there. I would save those ingots and blend them into a bigger batch later on. Yo could try casting a few bullets and see how well they fill out.

  3. #3
    Boolit Master
    Join Date
    Sep 2016
    Posts
    246
    Were those six ingots with the fizzing spots poured from the same melt as the rest of your ingots? If so the other ingots are also questionable.

  4. #4
    Quote Originally Posted by kevin c View Post
    Were those six ingots with the fizzing spots poured from the same melt as the rest of your ingots? If so the other ingots are also questionable.
    Yes. They were the last ones, I only know because that is how I had stacked them. There is nothing visually similar to the rest, and I dropped some drops of muriatic acid on random other ones and no fizzing of any kind on the others.

  5. #5
    Boolit Master

    dondiego's Avatar
    Join Date
    Jan 2013
    Location
    Milan, MI
    Posts
    1,795
    Sounds like the fizz may be from some dross or other type of contamination.

  6. #6
    well I decided to melt down the suspect ingots by combining them with around 2 ingots worth of melted (lead) clip on wheel weights. I slowly added in the suspect ingots, fluxing along the way and scooping off the dross as I went. Once I had everything up to 650F and was happy with the look in the pot, I brought my 2 cavity 356-120T mold up to temp an cast 6 bullets. They filled out nicely and I quenched them. When I pulled them out of the water they looked like nice 9mm bullets. I poured the rest back into ingots.

    Perhaps dondiego is right and the fizz was from some other range contaminant that I was able to flux out on this run.

    The learning never stops!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check