I ran across a used RCBS 358/ 180 gr GC silhouette mold at a local GS. I really did not want a GC mold but the price was right and the blocks looked good so I bought it. I used it for the first time tonight and noticed that the sprue plate was binding. I loosened it slightly and then noticed that the sprue on the rear cavity was not cutting flush. Looking at the plate closely I noticed that it was bent. Apparently the mold had been dropped with the cutter in the open position. My question is can I straighten the plate sufficiently to make a square base or will I need to contact RCBS for a replacement?