Graf & SonsWidenersLee PrecisionTitan Reloading
Inline FabricationStainLess Steel MediaRotoMetals2MidSouth Shooters Supply

Results 1 to 3 of 3

Thread: Crosman Intermounts.

  1. #1
    Boolit Master

    Join Date
    Mar 2005
    Location
    Northern WI Gods Country!
    Posts
    2,372

    Crosman Intermounts.



    These have gotten bad reviews because these current mounts 459 tend to wiggle when on the gun. I was told that the older discontinued 457 mounts didn't do that. These are a cheap way to mount optics on your Crosman multi pump 1377 ect and CO2 (2240) ect with out buying and installing a steel breech. You have to shim the bottoms of the mounts. Do this and they are rock solid. First thing you do is take out the cheap Chinese screws that can strip in the head and replace with American made screws. The size is 3mm x 16mm. Then buy a roll of magnetic tape with adhesive on one side. Cut off a piece about 1/8th wide and trim one end to fit the bottom of the mount. Put tape on each side of the tube below the barrel where the mounts will go. Set mounts in place and tighten down. With the tape shims the mounts are rock solid and you should be able to mount any optic to them.
    A gun is like a parachute: If you need one and don't have one, you won't be needing one again.

  2. #2
    Boolit Master

    Join Date
    Mar 2005
    Location
    Northern WI Gods Country!
    Posts
    2,372
    11 dollars for these and a 4 dollar roll of magnetic tape makes for a cheap way to mount optics if you don't want to pay for the more expensive 35 to 40 dollar plus steel breech and have to take your gun apart to install. I have two guns with steel breech on them, but they were custom shop guns. I find if you want the steel breech and other mods like the shoulder stock the custom shop is a cheaper way to go.
    A gun is like a parachute: If you need one and don't have one, you won't be needing one again.

  3. #3
    Boolit Master
    Join Date
    Apr 2010
    Posts
    881
    The problem is the mounts are made for a certain size tube. theres a B272 mount also. Im forgetting but ones for smaller tubes ones for larger.
    Air venturi makes on that fits the .5" tubes. I run that on my crosman 1400s

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check