When switching from J-Word to cast/lubed it is highly recomended you clean down to bare metal and vice versa going from cast to J-word.
Do you treat the barrel the same when switching from cast/lubed to cast/PCed?
When switching from J-Word to cast/lubed it is highly recomended you clean down to bare metal and vice versa going from cast to J-word.
Do you treat the barrel the same when switching from cast/lubed to cast/PCed?
Big Bore = 45+
I hear tell that you should clean between J words and cast. But i dont shoot a lot of jacketed only some here and there so i dont. I will run a bore snake down it when switching.
I do not clean between PC and Lube.
Never had a problem with accuracy.
Sent from my SM-G950U using Tapatalk
"Speak softly and carry a big stick; you will go far."
~Theodore Roosevelt~
I don't clean that much with either J, lube or PC. Think about this, I run a copper gas check on over half my bullets. Am I shooting cast or copper ? Have also heard folks say to shoot a few jacketed after shooting cast to clean the lead out. Key is bullet fit IMHO. I have yet to lead a bore with one of my bullets.
MyFlatline - Even with the gas check you are shooting cast - due to the lube.
Rcmaveric - I see a big difference with cleaning the results of Copper/powder fouling I when I switch to cast and the same when I switch from cast to j-word with the lube/powder fouling. Running a bore snake down the barrel does not remove all the lube/powder fouling from a cast bullet.
Shooting pistols you may not see much of a difference but when your are shooting a rifle - I know there is a big difference in 100 yard group size.
For my own piece of mind - I am going to clean my rifle down to bare metal before I shoot PC'ed bullets.
Big Bore = 45+
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |