Sure. OK. No sweat. Wasn't even trying to start any argument. No intention of that.... You appear to have become a bit "set off" by my post. I really do not understand why.
I just pointed out that your comments do not reflect others data. And that data I shared was only from the Castpics.net source. Which is not just some BS data that makes no sense, nor goes against safe limits.
I could have shared more info/data from others, including my own data for the .380 & 9mm. Not going to do that. There are a lot of sources folks can use to find out the info they need. I was only trying to point out that your comments were not universally shared by others. It is on you to feel any affront, as none was meant.
You and I disagree on this & so be it. Don't let it ruin your day.
I just shared what I know, & have researched BEFORE I posted. Some things that have worked for me & others who have done similar. Just like YOU mentioned what you know & have done...
IMO, your just dismissing data that is shared on the internet regarding firearms data can go BOTH ways...
Think about that.
If You dismiss others comments & results posted on the internet, based on your "own experience", how can you expect others to accept YOUR data & experience posted on the internet?
They are both posted on the internet, so does that make both of them suspect?
Possibly.
Yes, there are irresponsible things posted on the internet & there is also responsible info to be found on the internet. YOU are not the only authority , nor the deciding source for what is or what is not correct info or correct info, nor irresponsible info, or responsible info.
Please keep that in mind.
"I" do..
Regardless, it will be up to the OP to decide what She & her "Sig. Other" want to believe what they find on the internet or even here a CB.GL forum, no matter what you & I say here. I posted some data & can offer more data that will substantiate that your comments may not be as common for others, as it has apparently been for YOU.
Respectfully Yours, indeed...
To any & all... This is the disclaimer...
Verify & corroborate data you are presented with, no matter the source, & always work up loads for your own firearm from the minimum loads up & do not start with the maximum. Consider that the firearm or test barrel, as well as components like primer type, etc., do not match YOUR firearm & components, so adjust accordingly & work up slowly being SAFE.
I hope everyone has a wonderful day & don't let too much get to ya. Ain't worth it...
P.S. - No one mentioned a 3" barrel but you. Don't know where ya decided on that. but No Worry. I won't...
"Gleaning questionable data"?
Where????
And... about those "unsafe practices"... who mentioned any?
No need to answer, but that is an "unsubstantiated allegation" you may wish to be very careful with using...
I'll stop there. You must have been having a bad day with all these "digs" with based on what???
I hope you feel better.