Well sizes the cases and expands great. Went to seat a bullet two issues 1) bullet seat stem made hard impressions into the bullet and 2) crimp ring scrapes the feature of the bullet nose which is of diameter (.380 dia).
Solution I took the stem out and took a couple of my bullets already casted and put valve grind compound and shaped the stem into a close copy of my bullet and rounded the edges w a 44 mag copper bullet. Also the crimp ring remedy was to use a bore mop and valve compound soaked it, worked it on my drill for awhile then cleaned it up... took a dummy loaded case w valve compound on the bullet and turned it by hand till it felt free...cleaned the bullet off and put more compound and twisted it by handtil it felt free again. Cleaned everything off w engine degreaser and soapy water, ballistol it and baked on a low temp and reassembled