Attachment 222630
This is a 41 caliber mold design in the hammer series we are full spectrum now 458 caliber, 44 caliber, 41 caliber, and now 357 caliber.
MiHec 411 Hammer 2 or 4 Cavity Brass Cramer Plain Base or Gas Check Hollow Point mold.
This is a new boolit design (scaled down from the popular 462 Hammer). This will be suitable for any 41 Special/Magnum (or longer versions) along with the 41 Mag Henry and Marlin firearms. It will cast at about 0.411" dependent on your alloy. The weight is as shown on the drawing dependent on your alloy of choice. Meplat to crimp = 0.295".
We will need enough people to commit to this so Miha uses up 100 HP pins. We will run this until we get the number we need or more, then it is up to MiHec to decide when to make it.
Pins included are: For the Hollow Point Mold are 1) Large HP pin, 2) Small HP pin, probably a penta, 3) Cup pin, 4) Blank pin for a flat nose or in the case you don't want HP pins sticking out the mold.
Prices are -
- 2 Cavity HP all pins included 95 Euro's (80,75 with discount)
- 4 Cavity HP all pins included 135 Euro's (114,75 with discount)
- 4 Cavity solid Brass 95 Euro's (80,75 with discount)
- 6 Cavity solid Aluminum 95 Euro's (80,75 with discount)
If you want handles they will ship with the mold for 20 euro which is a deal on a great pair of handles!
The above prices do include the 15% group buy discount!
Prices are somewhat variable due to the exchange rate.... be aware of this.
Sequence of events: Participants order molds and are placed on the list, the Group Buy will close (which will be posted on the thread) at some time determined by MiHec, the molds are made from the orders on the list at the time it is closed or by altering what you want via PM to MiHec after it's closed. Extra molds should be available... order them by PM to MiHec or contacting MP Molds directly . Invoices will be sent out via e-mail from the listed e-mail addresses and you pay by using Paypal...... It is my understanding the invoice will be in Euros which Paypal converts from Euros to dollars dependent on the time that occurs. After you pay, the mold gets shipped.
Post your disguised e-mail address (imashooterATgmailDOTcom), mold choice (2 or 4 cavity), base style (PB or GC) and number of molds wanted (one to however many).
[SIZE=5]WE WILL NEED ABOUT 12 COMMITTED TO THIS TO MOVE IT TO AN ACTIVE BUY SO WE ARE RUNNING THIS ON TWO GB SITES TO TRY AND GENERATE MORE INTEREST QUICKER SO WE CAN CLOSE IT QUICKER!