The mold rest under my Lee 20# pot does not work well with my new Mihec 455 220gr HB mold. Hitting the hole requires a very precise geometry and the pins are gettin in the way. Anybody got a good setup recommendation to make this work easier?
The mold rest under my Lee 20# pot does not work well with my new Mihec 455 220gr HB mold. Hitting the hole requires a very precise geometry and the pins are gettin in the way. Anybody got a good setup recommendation to make this work easier?
I mainly use a Lee 4-20 and MP moulds. Because of this, I place the pins on the right side of the mould instead.
I get a block of wood, cover it with betal and use that to slide the mold on
http://castboolits.gunloads.com/show...-Mold-Rest-Mod
http://castboolits.gunloads.com/show...ide-lee-pro-20
http://castboolits.gunloads.com/show...-Guide-Adapter
I've got that NOE mold guide and it is really sweet. Much better than the homebrew thing I cooked up
I just use a piece of scrap 2x4. It doesn't have a guide, but I don't ever have any problems just lining up the holes as I go.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |