I bought this assortment to get going on Cowboy silhouette with a 30-30 but never managed to buy a rifle to make it happen. A pistol cartridge rifle has worked too well to switch and who needs another rifle anyhow? Well, maybe you do and here's a good boot down the road to make it work.
This starts with a set of Lee Pacesetter dies that also has a die marked 3030 A4. The basic dies include FL sizer (D3), bullet seater (I3) and factory crimp die; a dipper and shellholder are present as well.
For brass there are 103 fired cases and a new unopened bag of 100 PPU cases.
In the boolit realm there is a used NOE SC311-165-RF mould, Lee "Bullet lubricating and sizing kit" that has no Alox, just the .311 die, ram and punch in the 2-piece plastic case. A bag of gas checks includes some new and some darkened (tarnished) checks.
Finally there's a Williams receiver sight marked 336.
This has been sitting in my reloading room for a while, time for someone to put it to use.
Asking $120 shipped. Not sure if the Lee boolit sizing die container will fit in a flat rate box, if you happen to live in AK/HI and know, please share the knowledge.
Kirk