I picked up a bunch of better quality E clips from my local hardware store.
I picked up a bunch of better quality E clips from my local hardware store.
Due to the price of primers, warning shots will no longer be given!
You never know how you rank amongst men 'til you have seen what will break another man.
The original "Bluejay" US Army/ US Navy 1945-1970.
That's my plan, well in 06 but it's similar in enough ways that it should be accurate. I have used the 150 Lee fn boolit over 16-18 grains of 2400...it does very well.
I want to use this in 300 blk and 06 both...should do well. May need to play with alloy and powder to get that just right.
In 300 blk I may be more of a challenge because I'll need today oahbit at higher pressure because of the small case capacity...but 06 should be a dream. Louisiana whitetail don't stand much of a chance this season
Sent from my Moto G Play using Tapatalk
Just got mine. Heat cycle it tonight and see how it does tomorrow. 8cav pb solid nlg.
Due to the price of primers, warning shots will no longer be given!
Anybody have any H110 load data for this bullet? My pc nlg weight is 142gns. It takes up less case capacity than the mjolnir. I load that at 12.0gns and it weighs 127gns. I will be shooting them in a gp100.
Due to the price of primers, warning shots will no longer be given!
Got it in and I couldn't be more excited!! Going to try Penta pins and large hp expansion tests now to prep for hunting season!!
Sent from my Moto G Play using Tapatalk
Mine was waiting in the mailbox for me tonight.
Just received mine! As usual, the finest work in the world!! Thanks bluejay75 and especially Miha!
mick27
Accidental
Last edited by bpatterson84; 05-19-2019 at 12:07 PM.
Has any one had trouble with the HP pins supplied with these molds? I ordered 2 one PB & one HP. When I tried to assemble the pins for the PB the threads were not right on the side they should be started from in all pins. So I started them from the wrong side and using the wrench I screwed them in all the way that cleaned them up enough they would start from the right side. Then I noticed when screwed in all the way and backing them out a quarter turn they still protruded out the other side of the HP pin. I put a couple in the blocks and sure enough the blocks wouldn't close. So I backed them out about two turns to get them inside the HP pin, but that left the sharp shoulder on the alignment pin exposed, now I'm worried about cutting the hole in the blocks out. The pins for the HP mold didn't have the issue with the threads but still protruded thru the pin. I thought before I added to a possible flood of e-mails to MiHa I'd put it up here to see if anyone else had the same problem or could give me any suggestions.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |