this is a rig i put together to deburr and make my jackets all the same after trimming them. i was never really happy with the pinch trimmer leaving a real sharp edge that usually does strange **** when swaging the bullet so i made this system to go in a standard case trimmer.. it is used to only clean up the jacket after trimming. it is not for trimming the jackets as this leaves a gnarly burr that you have to remove b4 you can use the thing.. but the adjuster goes inside the chuck and is used to fine tune the deburring depth.

Click image for larger version. 

Name:	1.jpg 
Views:	17 
Size:	66.6 KB 
ID:	219344
entire setup in exploded view.

Click image for larger version. 

Name:	2.jpg 
Views:	15 
Size:	71.5 KB 
ID:	219345
adjuster assembly.

Click image for larger version. 

Name:	3.jpg 
Views:	14 
Size:	67.0 KB 
ID:	219346
adjuster assembly installed in trimmer frame.

Click image for larger version. 

Name:	4.jpg 
Views:	13 
Size:	61.4 KB 
ID:	219347
completed deburring system.

Click image for larger version. 

Name:	5.jpg 
Views:	15 
Size:	73.3 KB 
ID:	219348
trimmed jacket not yet deburred..

Click image for larger version. 

Name:	6.jpg 
Views:	12 
Size:	65.3 KB 
ID:	219349
jacket in chuck ready for deburring.

Click image for larger version. 

Name:	7.jpg 
Views:	15 
Size:	64.0 KB 
ID:	219350
deburred jacket.

Click image for larger version. 

Name:	8.jpg 
Views:	17 
Size:	61.2 KB 
ID:	219351
finished bullet..