You can get a plain base, but all of these molds will come with all the pins to include a flat pin so you can cast solids.
I'll do 1 of this in .413 PB two cavity, just as long as it will fit both a S&W and Ruger cylinder?
bigben1948 at mchsi dot com
Steve
Steve, I will put you down for a mold, however since brass length varies and so does cylinder length read post #36 and you can measure your own sixguns to be sure.
What's going on with this thread, I posted I'd do one of these above and have never been added to the list? Nor, can I delete my first post/question?
Steve
What's going on with this thread is normal. We build up a list of wants and Miha builds the molds. A big spoonful of patience is required as these buys can take quite a long time. As long as 3 years in my experience. I added you to the list, but if you do not wish to make the wait let me know and I will adjust the list to reflect your wishes. Your first question is a common one and thank you for asking. As to deleting posts check with a moderator.