Here is a cast bullet that was designed to better or replace the need for the Winchester Silvertip. The HP options are updated a bit to include a solid pin, a Large HP pin, a Small HP pin, and a new Cup HP pin. This mold at this time is only available in PLAIN BASE. 2 or 4 cavity.
We will need fifteen to commit to this. We will run this until we get the number we need or more, then it is up to MiHec to decide when to make it........ it can be a long time.... be warned and no whining.
Pins included are: For the Hollow Point Mold are 1) Large HP pin, 2) Small HP pin, 3) Cup HP pin, 4) Blank pin for a flat nose or in the case you don't want HP pins sticking out the mold.
Prices are what MiHec says they'll be. I'll have to check that out.
Sequence of events: Participants order molds and are placed on the list, the Group Buy will close (which will be posted on the thread) at some time determined by MiHec, the molds are made from the orders on the list at the time it is closed or by altering what you want via PM to MiHec after it's closed. Extra molds should be available... order them by PM to MiHec or contacting MP Molds directly . Invoices will be sent out via e-mail from the listed e-mail addresses and you pay by using Paypal...... It is my understanding the invoice will be in Euros which Paypal converts from Euros to dollars dependent on the time that occurs. After you pay, the mold gets shipped.
Prices are somewhat variable due to the exchange rate.... be aware of this.
Post your disguised e-mail address (imashooterATgmailDOTcom).