Hello all, I've got a Ruger .380 I'd like to cast bullets for. I've used the Lee 356-102-1R mold, but that 1R round nose just doesn't fit into the lead of that little 380. I'm looking at the Lee 356-120-TC and from the photo with that Truncated Cone it looks like it would fit nicely. Comments? I'm also a bit concerned about the 120 grain for the .380 - I do plan to use this solely for paper punching with very light loads around 600 or so fps. Comments?
Thanks to all for any comments and suggestions - perhaps of other molds?
Ken H>