For no apparent reason, I have wanted an Ohaus or RCBS 10-10 scale. I don't know if it is the micrometer poise with locking screw that appealed to me (I get very frustrated when a poise moves unintentionally) or if it was just the cool factor, but I had to have one. Unfortunately I am cheap and always considered $100+ too much for a used scale or a new one from China when RCBS started producing them there. Well I finally found one on eBay the other day for $70 OBO. It wasn't perfect as the aluminum wire connecting the pan support to the bar had been replaced with a length or rebar tie wire and therefore the pan support weight was out of spec (by about 3 grains). I figured I would kick myself if I didn't at least make an offer, so I offered $60 and the seller accepted. It arrived the other day and it took me all of 5 minutes to adjust the pan support weight. It still needs a good cleaning, but the knife edges look good and so do the bearings. My test weights seem to indicate that a good cleaning will have it right back to like new performance. It will go well with my Ohaus 5-0-5