So I picked up a Lee 310-RF mold for my .44 magnum Super Blackhawk.
I got some cast up, gas checked, sized and lubed. This afternoon I loaded up a few test rounds, and now I'm second guessing myself.
I seated them to the 2nd crimp groove (the one that gives the shortest OAL).
Now I didn't load any nitro heavy loads, but they are on the warm side. I know you're supposed to start at the bottom, but I generally start in the middle.
I have some loaded with 21 grains of W296 and some with 18.5 grains of IMR4227.
Should I pull them and re-do them seated to the first crimp groove (the longest OAL)?
I don't think they're compressed, but they are close.
If I need to, thankfully I only loaded 20 of each, so it won't be that big an issue.
Thanks