TC speed loader. Just put the speed loader over the bullet, wipe excess lube off and push the bullet out.
TC speed loader. Just put the speed loader over the bullet, wipe excess lube off and push the bullet out.
i poured these maybe 6 months ago.
I'm going to give FM's speed loader method a try, but here is a link to SPG's website and there is a downloadable PDF article on pan lubing at the bottom of the page that I found very helpful. Basically just remove the hardened lube from the pan and push the boolits out point first.
http://www.blackpowderspg.com/spglube.html
I have used both methods, cutting and pushing through. Push through was a whole lot less mess for me.
Reviving an old thread...
I happen to have broken the lid on one of my t/c speed loaders. It's found a new purpose! Used this method to extract a set of REALs and also some old Maxi Balls. They are ancient (from when T/C still made them for the masses in 54cal) and the bore butter was junk.
Thanks for the idea FM!
Jon........................... did you shoot the harder REALS yes?
Yes they loaded a lot more snug in the bore and shot 3 shots into a ragged hole at 50 yards, open sights.
I got felt from Walmart and soaked them in 2:1 Beeswax/vaseline. When the felt hardened, I punched the wads out with a sharpened piece of pipe (sharpened first with a motorized grindstone then later periodically sharpened with a Dremmel). I use the same punch for overpowder cards made from cereal boxes.
And the same lube to put into the REAL lube grooves. It is flexible in cold weather and holds up nicely in hot weather too.
CVA Optimal Pro with Alliant Black MZ. Yeah, it's not a 'real' muzzleloader or a 'real' BP, but it's fun to load and shoot.
Chilled shot is around 2 to 3 percent antimony
Probably has some arsenic
Add 2 to 3 percent tin and you would be around 8 BHN
These bullets were cast with old lead pipe.
Check out the performance!
https://www.youtube.com/watch?v=raQZEcdXXUo&t=2s
Didn't have a lot of time,but I did get to shoot my 54cal TC on Sat. The 300gREAL bullet with homemade lube did good with 50gr of FFFg
Will report back with group size one day.also I used TC wad too
Last edited by jim 44-40; 04-30-2018 at 04:10 AM.
Did you mean 300gr? They don't make a 200 for the 54. They do make a 300 and a 380gr though.
Aim small, miss small!
Yes 300gr
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |