OK so its been a while since I posted any pics ..
This is a quick, down and dirty trial that should answer a few questions about PC
I took absolutely no time to make ANYTHING LOOK good just a test of the powder and bullet cleanliness
now to set the stage .. These are NOE 266-125 HP bullets that I cast over 2 months ago .. They have been sitting open on a cloth shop rag the entire time . Right beside the main door .. so wind, rain, dust hot cold you name it these bullets would have gotten anything that blew in the door when it was opened .. Which by the way has been numerous times.
Gas checks and first sizing were done on a Lee push thru sizer with bare hands ..
Then Dry tumbled with Harvest Gold (testing powder)
Then final sized
Alloy is 98/8
Load is 28 grns of WC846, CCI 400 SR primer Hornady brass
loaded and fired over a lab radar out of a 18" Alexander Arms AR and a YHM suppressor and a Pulsar Trail XP50 Thermal scope
used a hot hands at 50 yds for an aim point
Velocity achieved was 2406 FPS and ZERO leading
AGAIN I took no pains to make these look good just a test batch .. 2 plus months of whatever could get on bare bullets and performance was NOT effected in anyway. I did NOT clean bullets in anyway before dumping into the PC powder
PS I got a sub 1" group with 3 rds and a thermal scope .. Not an Ideal way to shoot groups
First pc is after GC, sizing then coating
Attachment 217192
Second Pic is after final resizing .. No coating was removed
Attachment 217193