I have a lee 7.62x38 pistol 3 die set for sale. It was made for converting and loading32/20 brass. I have only used this set to load actual ppu 7.62x38 brass. It workes good for this. This set is not carbide so the brass needs lubed when sizing. The dies are in good shape but the directions are worn and has a small hole in the middle. It comes with the 3 dies, shell holder,plastic powder scoop and is in Lee’s flat storage box. A lot of people used a small screw head to leingthen the bullet seater. I just put a lead .314 bullet under the bullet seater and It workes fine. 30$ plus shipping. I also have 222 pieces of once fired ppu brass. It isint polished,don’t have a tumbler. Some of the brass has been deprimed.brass is .25 cents each Total for brass 55$ Plus shipping. I will also throw in 65 once fired 32 h&r brass shot out of my pistole. I have in the past re sized this brass with the Nagant dies and reloaded it. After the first firing it bulges at the base to fit the chamber. After shooting it I just resize it using the Nagant die using light loads. It shoots good with the 32h&r brass but shoots even better more accurate after being sized in the Nagant die using 98 grain cast bullets. I will take checks or money orders. I live next door to the post office so I ship USPS. I charge actual shipping so what ever is cheaper usually priority mail small or medium flat rate box usually works good. Also if you buy the dies and the brass it should all fit in a medium box and save on shipping .Thanks for looking
|
   
   
|
|
