Missouri Bullet Co.

[jlh]

Is Missouri Bullet still "good to go?"......If not, who do you recommend?

Thanks

[jmort]

Yes
Lot of options
Unless I want a gas check I would use them

[Beagle333]

I like Missouri. I use Oregon Trail too.

[Jniedbalski]

The bullets I got from them are-very good. About two years ago I think when I got them

[rond]

The only cast that I buy.

[tranders]

I have used them quite a bit with good results other than one time got some coated 9mm projectiles that were not coated very well. I ended up tumble lubing them with Alox and used them up.

[tomj44]

http://www.acmebullet.com/index.php?route=common/home

[dverna]

Dardas is another good supplier...out of Michigan

[kipk49]

I purchased a box of .358 wadcutters from them, in 12 BHN. They seem to be well made, although I'm not sure if the coating was properly applied. After the smash test, I could see the coating cracking and coming off in some places.

[scattershot]

Beautiful bullets, well cast, and packaged very well. Check the diameters, though. I ordered .452, and the ones I have checked so far run .4505-.451. I’d say if you need hard cast bullets, it’s between them and Dardas.

[RAK2018]

I've bought quite a few pistol boolits from MBC. They worked great.

[Pumpkinheaver]

Good to go, at least last time I bought some from them.

[Uncle Dave]

I have used several calibers and styles from them and so far so good. Just be aware of the intended use and purchase the appropriate hardness of bullet to get obturation. They also can custom size -I have read. I have used only the Hi-Tek pistol bullets. I will either cast my own OR buy from them if I don’t have the molds.
Dave