Has anyone had any joy with this ?
I 3D printed a Sabot to hold a 240grn .44 pil I had cast for my Marlin. It was a spur of the moment thing as I was powder coating some .44 and I did some Lee 1oz slugs just for fun and visuals.
They worked, but accuracy was poor. I could hit a 2 foot square target at 25 meters but they went anywhere on the paper. When they hit the Sabot had opened and released the little Slug.
I tried two versions, the one pictured above where the sabot was a bore rider on a MEC wad sans its petals, and one not pictured where the Sabot sat inside the wad. Not real difference in group with either.