My loading gate spring broke, so I had to have it replaced.
External inspection is okay, but the surface of the gate does seem to be sunken in/recessed more than I remember the old one being. Hard to say as I don't have an image to compare to.
Cartridges insert fine, the issue is that after loading the base of the last cartridge loaded tends to want to stick on the inside edge of the loading gate rather than slipping in behind it. Net result - failure to feed. My workaround is to double check by taking the point of my knife - insert at the front edge of the gate to make sure the cartridge it slips off the edge and into place behind the loading gate.
45lc - primarily used by CAS.
Thoughts? And is it possible to remove and reinstall the loading gate without fully disassembling the rifle - perhaps through the magazine tube?
Thanks in Advance,
Tarheel