My '79 (or '80) Pro melt has been trouble free until lately the switch failed. A call to CS @ RCBS had me a replacement in 3 days @ no cost.......thank you, RCBS.
I'm attaching images from different angles of the replacement switch attempting to show that the attachment system is simply 2 plastic clips on each end.
I would imagine that in 37-38 years the switch design has changed. If it was secured by hardware on the back side it would look to me that I could remove the old switch using the "Bubba" method (breaking old switch) & install replacement w/o removing the cover.
Has anyone changed out a switch recently that could give me some insight?
I'm capable of removing & replacing the cover if that is the only method.
Thanks,
Henry