I want to as well. Just got a mold for #4s, and have a lot of hulls, wads, powder and primers. I'll figure out something that works.
That coyote I killed with the shotgun I posted was with some Federal goose loads left over from the pre steel shot days our local Alco was selling on clearance several years ago for $5 a box. They are 3", 1 7/8 ounce of BB sized lead shot. Quite ferocious and killed that one DRT from about 35 yards away. I would think #4 would be just as good or better.
The 7-08; used 120 grain flat points that were laying around (like for a 7-30 Waters). Loaded them hot because of the poor BC.
Uhg, what a mess.
That 287308 will be plenty.
The only thing hard about killing a coyote is getting a shot at the sucker!
my load is
Winchester hull 2 3/4"
21gr Green Dot
Winchester primer
RP12 wad
27 pellets #4 buck
Works good for me
You do your part and a cast bullet will do its.
http://www.handgunhunt.com/photopost/data/500/030.jpg Took this coyote at 65 steps with a .218 Bee using a 55gr, gas checked, cast bullet and a dose of H4198. She was 'real mangy', but her mate looked fine. By the time I reloaded he was 'gone'.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |