Hey all
I would like some inputs on subj molds for a 9mm mold. I am thinking I would like the 358-124-TC RG2 for my wife's Springfield Armory 9mm. The only hesitation I have will that style projectile feed properly. Anyone have any experience with this particular mold? Also it is available in PB or GC. I am leaning towards PB due to the velocity in a 9mm. I will be powder coating using Smoke4320's powders. Or is the general consensus that the TL-357-135RF RG2 (RD) would be a better performer? The latter is only available right now with GC. Regardless of which mold, I will be casting with COWW + 2%tin and then mixing with 25% SOWW to soften it - if that would be a good mix for the 9.
I should add here that I may also use this projectile as a lightweight round for my wife's .38 Special - depending on the actual diameter it casts at.
Any insight into these molds would be most appreciated.