MidSouth Shooters SupplyLee PrecisionReloading EverythingWideners
Inline FabricationRepackboxTitan ReloadingRotoMetals2
Load Data Snyders Jerky
Page 2 of 2 FirstFirst 12
Results 21 to 22 of 22

Thread: Excessive barrel/cylinder gap?

  1. 02-01-2018, 07:09 PM #21
    silhouette_shooter
    silhouette_shooter is offline
    Boolit Bub
    Join Date
    Feb 2011
    Location
    S.E. Arizona
    Posts
    69
    S&W allow for up ten thousandths. Freedom Arms won't go near that, mines approx .003 general consensus is not more than .006.
    Reply With Quote Reply With Quote
  2. 02-01-2018, 07:19 PM #22
    Outpost75
    Outpost75 is offline
    Boolit Grand Master Outpost75's Avatar
    Join Date
    May 2013
    Location
    over the hill, out in the woods and far away
    Posts
    10,169
    FYI for anyone who hasn't visited the page and read it, but the revolver inspection instructions are now a sticky and have been revised based on helpful comments I've received from professionals in the trade who lurk here:

    http://castboolits.gunloads.com/show...a-Wheelgun-101
    The ENEMY is listening.
    HE wants to know what YOU know.
    Keep it to yourself.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check