As the headline states I have a problem with the pneumatics on my Magma Bullet Master. When casting this evening an air leak suddenly appeared. The machine still works but the left mould knocker behaves strange but still knocks so the bullets drops out. Because of the leakage my compressor runs non stop so that won't last in the long run.
After removing 2 pairs of carrier arms and a closer inspection, the leak was located to the back side of the left solenoid. It's really one way to locate this and that's to feel with your hand and fingers. It's in a very tight spot. Anyway...... The leak is on the left, wall side of the machine. I'm not sure but could this be a went hole on the solenoid, and it somehow got stuck in a partially open position?
The knocker looks a little weak, that's only natural when the preassure is a lot less than it should be because of the leak.
Any idea? A new air solenoid? Changing this could be interesting.....
Thanks!
Attacing pic
Sent fra min SM-G930F via Tapatalk