Hello Guys and Thanks for looking.
CLOSED!
Please contact Miha direct for any changes or if you want to see if he has an over run available.
Thanks to everyone who signed up!
With Miha's permission and a big Thanks to the original designer we are going to run this group buy again. This is has been ran 3 or 4 times and everyone has raved about this bullet!!
I personally have a 2 Cavity version and have about worn it out!! It shoots well in everything I have ever shot it in from my N frame to my SP101 and my lever guns.
This is a very accurate and great one bullet for all occasions mold!!!
Here are the specific's -
This is a dual use 357 boolit, the top crimp groove is for the short N-frame S&W 357 cylinders and the bottom crimp groove is for the 38 Special and long 357 Mag cylinder wheel guns. Meplat to crimp groove is 0.318-in and 0.357-in.” Weight is approximately 158gr HP and 170gr solid. I have a solid version of this mold and it casts 0.359-in with WW and 2% tin. Standard Lee 6 cavity handles will work. Miha also offers his higher quality handles too that can be added to the order.
Here is a little eye candy to look at from past runs.
Attachment 211596Attachment 211597Attachment 211598
This buy is going to offered in -
Cramer Pins included: 1) Large HP, 2) Penta HP, 3) Small HP, 4) Cup HP, 5) Blank pin for flat nose
- 2 Cavity HP all pins included 95 Euro's (80,75 with discount)
- 4 Cavity HP all pins included 135 Euro's (114,75 with discount)
- 6 Cavity solid Brass 95 Euro's (80,75 with discount)
- 8 Cavity solid Aluminum 95 Euro's (80,75 with discount)
The above prices do include discount!
If there is interest in Hi Tek design we can do that too we will leave it up to demand.
The price will be converted to dollars at the time of invoicing thru paypal and the discount will be applied then.
If you do not do paypal contact Miha directly and he will work out the details with you.
This buy is set up to go into last call at 20 molds and then it will close when Miha calls it. These runs take a while some times and patience is required he has done a lot to speed up production with a bigger facility and more equipment but it is still a time consuming process and let's give him some grace to make these fine molds!
No one else is producing a Cramer style mold with these kind of options for pins and the price!
This group buy is set up with a 15% discount it is applied at the time of check out.
He is still closing out some molds on his web site but those are for in stock molds only to help make room on the shelves.....