This mold will be offered cut to .691" depth for a 220gr WFN, .631" depth for a 200gr WFN, or .601" depth for a 190gr WFN.
NO MIX AND MATCH IN THE SAME MOLD BLOCK!
All molds come with all three pin sets. There are two hollow point pin sets and blank pins for casting solids. Both the round and penta-pins will remove 5gr from the solid boolit. So if you buy a mold cut for a 190gr WFN and use the hp pins you'll get 185gr HP boolits.
----------------------------------------
Options: (€135 - 15% discount = €114.75)
1. 4-cavity brass mold cut for 220gr WFN
2. 4-cavity brass mold cut for 200gr WFN
3. 4-cavity brass mold cut for 190gr WFN
P. Cavities cut without lube grooves for a dedicated powder coat mold.
----------------------------------------
To place an order post your disguised PayPal email address, and the options / quantity you want. I will record your order on the participation list below. Please then check that I have recorded your order correctly. Miha will contact you at the email address listed next to your name on the list when he is ready for payment / delivery.
Please post your orders like this:
Oreo, 3P, jdecar1 at hotmail dot com
----------------------------------------
GEL TEST DONE BY The Chopping Block
LINK TO THE RESULTS THREAD