About a month ago I ran across a thread around here somewhere talking about .32 SW, .32sw long, etc.
I got curious.
First off knowing that I don't play well with recoil and muzzle blast why do I always have this hankering for big bore pistols? Maybe it was time I grew up and went the other way.
So I did some reading, some looking on gun broker.
In the end I found this pair.
Both H&R's, nickle model is 733 I believe, blued is 732.
I'd of liked to have had a 4" barrel on one of those but this is what I ended up with.
Nickle one cost me 150$, the blued one 20$ less. Plus of course shipping, FFL fee's.
So I ordered 500 Starline .32sw long brass. Mold, I used the Lee .314 90 gr truncated Cone TL. Some got sized to .312 as they were a bit big.
CCI small primers and 2 grains of Red Dot complete the load. They have not been fired yet. But the loaded rounds drop right in like the should, and slide right back out again.
All I have done to either was just give it a quick cleaning and oiling.
Other than .22lr these are my first revolvers.
Really looking forward to the first range trip. But it is in the -20's right now and the range is closed for new years.
Next week.
Also wanted to send a big thank you to outpost75, we had a little flurry of PM's, I was just wanting to make sure I was headed down the right load with these guys.