Anyone know what press these came off of?
Thanks for the help
~Bazoo
Anyone know what press these came off of?
Thanks for the help
~Bazoo
Last edited by Bazoo; 12-31-2017 at 12:15 AM.
Any help is appreciated. I found them in a box of reloading stuff.
NOT off an rcbs single stage or a hornady lnl thats about all the help I can be
I have searched trying to figure what they are for, and havent had any luck so far.
Thanks Rancher
Man, those look familiar. I just can't place them. Seems like have worked on whatever it is they go with. You might have better response if you post the image in your first post instead of just a link.
PM me if you need help posting photos.
David
Sometimes life taps you on the shoulder and reminds you it's a one way street. Jim Morris
what kind of other stuff in the box. Size? any other clues might help. Sure seems like I've seen something like it also.
Take a kid along
They look familiar to me, too. Am thinking they came out of a 1911 or M1 Garand.
Member: Orange Gunsite Family, NRA-Life, ARTCA, American Legion, & the South Cuyahoga Gun Club.
Caveat Emptor: Do not trust Cavery Grips/American Gripz/Prestige Grips/Stealth Grips from Clayton, NC. He will rip you off.
I think not1911
Not 1911 parts. They came in a box of reloading stuff, A rockchucker press, dies, and brass that was given to me 2 years ago. There was a chunk of white plastic in the center of the round part of one, as if it had a knob or wheel that had broken off.
I dont know how to post pictures in the thread without photobucket. I'll see if I can figure it out.
Figured out imgur.
Last edited by Bazoo; 12-31-2017 at 12:16 AM.
Looks similar to some belt fed starter tabs.
They don’t index anything though, just poke them through the gun and grab them from the other side to start a new belt without opening them up.
It looks like it could be a chain stop for a light duty chainsaw sharpener. But I can't find any matches for it.
I give loading advice based on my actual results in factory rifles with standard chambers, twist rates and basic accurizing.
My goals for using cast boolits are lots of good, cheap, and reasonably accurate shooting, while avoiding overly tedious loading processes.
The BHN Deformation Formula, and why I don't use it.
How to find and fix sizing die eccentricity problems.
Do you trust your casting thermometer?
A few musings.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |